Tuesday, December 8, 2015

COP'S - V.2

So the coil packs i was running sat a bit proud of the center plate and made it hard to find a way to mount them. Because they were from a 2az-fe they are the longer of the toyota coil packs.

So i went back to the wreckers (Pretty much a second home..) and swapped out the 2az-fe ones for some 1nz-fe coils from a Vitz.



These are slightly shorter and actually seal around the center plate.
I then took out the center plate and drilled some holes for the coils to bolt down to.
Because the mounting part is slightly raised i cut some pipe so the bolts don't pull the coils down to much.



I then splashed some paint on the bolts and center plate.
First a light primer coat, then a good coat of satin black.






Put the rubber back on and tightened up the coils.!









And with that they are all installed.!
Now to wait for a 3D printed dizzy cover...
Check here to buy your own Nylon 3D printed plastic dizzy cover. (both 16v & 20v available)

No comments:

Post a Comment